RealCADD and iPocket Draw

George, I'll try that. The only problem that I can see is that sometimes I'm drawing a table, sometimes I'm drawing a 15' x 8' bookcase. And I need them to fit on an 8-1/2 x 11 sheet of paper. Like I said, presentation, not architectural model.

I've asked Eric if there was a way to set up templates and save them, but DB doesn't have this ability.

Thanks for the continuing help,

M

debenriver wrote:Eric – that would be good option to consider in RC – perhaps ⌃⌘V with a placement option like ⌥⌘V has – that would be really good!

The function already exists for Library objects (Put at scale option) – I draw all my Library objects at 1:1 and then use the Put at scale option – works really well!

Yes George, it is a good suggestion !

Thanks.

Guys, I've started a new thread. May you can explain it...