Move multiple points.
Posted: Sat Aug 23, 2014 10:25 pm
Eric,
Please look at this drawing. With DrawingBoard, I could drag a selection box around line CD, which would also select endpoints of E and F. Then, I could move CD to the right. The right ends of E and F would stay where they are, but the left ends would shift with the vertical line.
With RC or iPD, this doesn't seem to be possible. I can move CD, but I have to trim the ends of E and F.
Is this somethng you could do?
Thanks,
Mike
Please look at this drawing. With DrawingBoard, I could drag a selection box around line CD, which would also select endpoints of E and F. Then, I could move CD to the right. The right ends of E and F would stay where they are, but the left ends would shift with the vertical line.
With RC or iPD, this doesn't seem to be possible. I can move CD, but I have to trim the ends of E and F.
Is this somethng you could do?
Thanks,
Mike