Angle dimensions & crashes
Posted: Mon Nov 28, 2016 5:43 pm
Hi Eric
I can't seem to get an angular dimension between two lines at 5º or less. It just bongs at me. 5.01º and greater will produce an angular dimension. Doesn't seem to matter how far I separate the two lines (I though it might be something to do with insufficient space, but I don't think that is the case).
I also still get crashes from time to time – always (I think) when I mouse over the Edit pallet fairly fast.
And I get "RealCADD not responding" so I have to Force Quit, on a fairly regular basis if I try to find an endpoint on a polycurve – if I break the polycurve (Option-cmd-L) into lines then no problem. The polycurves in question are a shallow long open polygon – usually imported from elsewhere via dxf. I've learnt to break the curve up before attempting a snap – but every now and then I forget! It's not very important – just a bit frustrating at times.
I'm using the new 4.62, Cocoa.
Otherwise all is good
Cheers -- George
I can't seem to get an angular dimension between two lines at 5º or less. It just bongs at me. 5.01º and greater will produce an angular dimension. Doesn't seem to matter how far I separate the two lines (I though it might be something to do with insufficient space, but I don't think that is the case).
I also still get crashes from time to time – always (I think) when I mouse over the Edit pallet fairly fast.
And I get "RealCADD not responding" so I have to Force Quit, on a fairly regular basis if I try to find an endpoint on a polycurve – if I break the polycurve (Option-cmd-L) into lines then no problem. The polycurves in question are a shallow long open polygon – usually imported from elsewhere via dxf. I've learnt to break the curve up before attempting a snap – but every now and then I forget! It's not very important – just a bit frustrating at times.
I'm using the new 4.62, Cocoa.
Otherwise all is good
Cheers -- George