Hi Eric
I have been importing some file with multiline text blocks, contained within bounding boxes into ipocket draw. When imported, via dxf, the text ends up on a single line, and is not useable.
Is there a procedure for dxf importing that allows multiline text or an alternative formatting/procedure that keeps the text appearance ?
Regards
Martin H
Muiltimine test
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Muiltiline test
Thanks Eric,
Had not intended to oost same query twice, wasn't aware of the delay in the submittal process.
The dxf 12 solution works well. Doesn't support Fills through
Look forward to future versions, easily the best cad system for iPads, but lots of room for enhancement.
Look forward to your future versions.
Regards
Had not intended to oost same query twice, wasn't aware of the delay in the submittal process.
The dxf 12 solution works well. Doesn't support Fills through
Look forward to future versions, easily the best cad system for iPads, but lots of room for enhancement.
Look forward to your future versions.
Regards