Hi Eric
I have started to use "Symmetry with an axis", which I really haven't up til now.
If you look at the image below, I want to flip the curved line so that it is vertically symmetrical about the red line. So I want to make image A into image C.
So, in Image A, I select the curve and ⌘D it. Then I select Action >> Symmetry with an axis and click on the red horizontal line.
But instead of ending up with image C, I end up with image B – the curve flips horizontally around whatever point on the red line I select.
How can I control this to do a vertical symmetry??
Cheers -- George
Symmetry
-
- Posts: 702
- Joined: Sat Dec 03, 2011 9:19 pm
- Location: Maine USA and Suffolk England
- Contact:
-
- Posts: 702
- Joined: Sat Dec 03, 2011 9:19 pm
- Location: Maine USA and Suffolk England
- Contact:
Re: Symmetry
I've just realised how to do it! Click on one end of the red line, drag to the other end and click!
Perfecto!
I've solved my own problem!
George
Perfecto!
I've solved my own problem!
George
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Symmetry
Yes George, perfecto !debenriver wrote:Perfecto!
I've solved my own problem!
Eric Pousse