One of my problems has been dividing a line into segments, and then drawing another line off of each segment. Sometimes, I have difficulty finding the endpoints.
I noticed that in RealCADD, you can divide your line, and then, drag-select to make the segments appear. Then, you can switch to the line tool, and draw off of a segment. (Unfortunately, this only works once. You have to reselect the line each time, to see the segments.)
If you do the same thing in iPD, you can drag-select the line, which shows the segments. But when you switch to the line tool, the segments go away. IWBN if they would stay, at least long enough to start your next line.
Request for dividing line
Request for dividing line
Mike Rosen
Seattle, WA, USA
Mac OS Ventura 13.1, iOS 11.4.1 on iPad Pro
Seattle, WA, USA
Mac OS Ventura 13.1, iOS 11.4.1 on iPad Pro
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Request for dividing line
Mike,
Yes, I see what you say.
I don't remember why I deselect all objects when the user chooses a tool.
Perhaps for a good raison!?
I will test what happens if I deselect all objects after.
Yes, I see what you say.
I don't remember why I deselect all objects when the user chooses a tool.
Perhaps for a good raison!?
I will test what happens if I deselect all objects after.
Eric Pousse
Re: Request for dividing line
Eric, merci.
Mike Rosen
Seattle, WA, USA
Mac OS Ventura 13.1, iOS 11.4.1 on iPad Pro
Seattle, WA, USA
Mac OS Ventura 13.1, iOS 11.4.1 on iPad Pro