Page 2 of 2

Re: A new option and a new dialog

Posted: Thu Jun 18, 2015 12:59 pm
by debenriver
Hi Eric

I don't think "Positive y up" is working on "Move & duplicate" – works fine on "Duplicate & move".

George

Re: A new option and a new dialog

Posted: Thu Jun 18, 2015 4:10 pm
by Mikerosen
Dynamic vs. Static:

I didn't use the old Parallels (what you are now calling Dynamic) except when I wanted to do an offset, like a rectangle within a rectangle. With the new Static mode for a simple parallel, might it make sense to change the Dynamic mode to a separate tool, Offset?