Page 1 of 1

Region cut outs...

Posted: Fri Jun 12, 2015 9:55 am
by Caddy
Bonjour Eric

Here is my simple question: How to create a colored profile without any color (not white, not black, etc …) in the inner circle?
Colered profile.png
Colered profile.png (11.11 KiB) Viewed 5354 times
One could use a workaround, splitting the profile in 2 parts near the middle of the inner circle… coloring each part, grouping together … but that is time-consuming.

Cordialement
Hubert

Re: Region cut outs...

Posted: Fri Jun 12, 2015 12:03 pm
by Eric Pousse
Bonjour Hubert,

There is only two solutions :
- a color in the inner circle,
- a workaround, like you describe with 2 parts or with a complex polygon but also time-consuming.

Why don't you want to have the inner circle with a color?
You can put it below all other objects.

Re: Region cut outs...

Posted: Fri Jun 12, 2015 12:34 pm
by Caddy
Hello Eric
Eric Pousse wrote:Why don't you want to have the inner circle with a color?
You can put it below all other objects.
In case of 1 item per drawing there is no need for color. When I start a complex design I'm going to create an assembly drawing. Ok, a section will be indicated by a hatch. But if I want to accentuate a solid surface I prefer pastel colors - so looking through a hole what is not empty, that is difficult for everyone :D :D :D.

In the case of hatches there is something in your application, that can calculate regions. I thought in case of colors that could work in the same way...

I'm hoping you'll find a way, my be later...

Hubert