Page 2 of 2

Re: Moving objects from a certain layer to another

Posted: Wed May 27, 2015 3:14 pm
by RockinHorse
Eric Pousse wrote:Thank you Hubert !

I will wait your next posts.
Bonjour Eric

I'll try to keep my promises. I'm ready now to send all information that I worked out to you by E-mail. For the translation there are remaining still 67 expressions. The best will be you take a look inside and it's up to you how to proceed. May be there is one serious issue. But you know your soft - for it's an assumption only. Also I have explained a proposal that could create some (more) work for you - if you don't know what you should do with your free time :)

I'm going to start my new design project next week as scheduled. I feel fine for that to do it with RealCADD - there is no doubt about it. I think I'll have in the next time some more subjects to discuss.

Greetings from rainy Germany
Hubert

Re: Moving objects from a certain layer to another

Posted: Fri May 29, 2015 9:26 am
by Caddy
Bonjour Eric

It seems to me that for the thread's subject is nothing more to do.

There is a very fine way to move the objects from one layer to another:
-- activate the source layer
-- uncheck "Selection on all visible layers" because this is a safe way to avoid any trouble
-- create the selection - step by step or all
-- cut the selected objects by "alt/cmd"+"X"
-- activate the target layer
-- paste what's in the clipboard now with "alt/cmd"+"V"
-- check "Selection on all visible layers" if needed

That's it and it works pretty fine and pretty fast ;)

Greetings from Germany

Hubert

Re: Moving objects from a certain layer to another

Posted: Sat May 30, 2015 5:04 pm
by Eric Pousse
Yes Hubert, it is exactly the right way to do that.